15 voltage inputs

Fifteen single-ended channels deliver 15 input words to the controller.

Shared return group

All channels share one common; grounding and reference design must be checked.

15-bit conversion

0.3125 mV per count for ±10 V process and machine signals.

IC200ALG263 brings fifteen single-ended ±10 V signals into a VersaMax CPU or supported network interface through one high-density module. Because the inputs form one group with a shared return and no channel-to-channel isolation, the common reference, cable shielding and field grounding should be reviewed before existing conductors are moved.

The module is powered from the VersaMax backplane and provides 15 analog input words. Its 7.5 ms update and 32 Hz input filter suit general process-voltage acquisition; they should not be mistaken for a high-speed sampling function.

Process voltage signals

Collects fifteen ±10 V measurements in a compact VersaMax station.

Machine feedback

Reads compatible voltage references where a shared return is acceptable.

Remote I/O stations

Works through supported VersaMax network interfaces after firmware review.

Maintenance replacement

Restores an installed channel group after wiring and configuration checks.

Confirm the module, carrier and shared-common wiring

Use a clear front image showing IC200ALG263 and the OK indicator, plus a side-label and carrier photograph. Include the common-return and shield termination in the installed photo so the electrical reference can be checked.

Is IC200ALG263 suitable for fifteen independent ±10 V sources?

It accepts fifteen single-ended ±10 V inputs, but they are one group with a shared return and no channel-to-channel isolation. Confirm that the sources can share the same reference without creating ground-current or common-mode problems.

Can IC200ALG263 power the connected transmitters or sensors?

No. The module electronics use VersaMax backplane power, while field devices need their own suitable supply. Verify the field supply, common return and polarity before landing conductors.

What performance should I expect from IC200ALG263?

GE specifies 15-bit conversion, 0.3125 mV per count, a 7.5 ms module update and a 32 Hz input filter. Confirm these values are appropriate for the signal dynamics; this is not a simultaneous high-speed acquisition card.

What should I check if the IC200ALG263 OK LED stays off?

Check carrier seating, backplane power, controller or NIU recognition, configuration and the module's internal-power/A-D diagnostics. The green OK indicator is not simply a field-voltage lamp.

Can IC200ALG263 be selected only by its similar front appearance?

No. Confirm the complete catalog number, carrier, supported CPU or network-interface firmware, project configuration and wiring. Similar VersaMax analog modules can use different signal ranges or channel arrangements.

Why can IC200ALG263 readings become noisy after replacement?

The usual checks are the shared common, shield grounding, cable routing and source reference. Use shielded signal cable and follow the official grounding guidance, preferably grounding the shield at the source where the installation allows.

Need a verified IC200ALG263 for an installed system?

Share the full nameplate, installed configuration, clear connector or terminal photos, quantity and destination. Myrtle will review model identity, compatibility and delivery requirements before quotation.