There have been many new developments in the field of DCS integration, mainly reflected in the following aspects.
(1) System functions are developing towards openness. The structure of traditional DCS is closed, and it is difficult for DCS from different manufacturers to be compatible. A typical example is the iNICS system, which builds an open application ecosystem based on a unified data foundation and low-code platform, supporting the unified reuse and collaboration of knowledge, data and applications. Open DCS will give users greater autonomy in system integration. Users can select equipment and software resources from different manufacturers to connect to the control system according to their actual needs, achieving the best system integration. This includes not only the integration of DCS with DCS, but also the broad integration of DCS with PLC, FCS and various control equipment and software resources.
(2) Instrumentation technology is developing towards digitalization, intelligence and networking. The intelligentization and networking of industrial control equipment can further decentralize the functions of process control, realizing true "all-digital" and "fully distributed" control. Furthermore, the high precision, repeatability, and reliability of these intelligent instruments, along with their bidirectional communication and self-diagnostic capabilities, make system installation, use, and maintenance more convenient.
(3) Industrial control software is developing towards advanced control. The widespread application of various advanced control and optimization technologies is the most effective, direct, and valuable development direction for enhancing the overall performance of DCS. This mainly includes the development and industrial application of software for advanced control, process optimization, information integration, and system integration. For example, the iNICS system recently released by China General Nuclear Power Group (CGN) deeply integrates digital twin and artificial intelligence technologies to construct a closed-loop intelligent system covering the entire process of "perception-analysis-decision-execution," achieving for the first time functions such as fault warning, intelligent monitoring, and decision support. Industrial control software is developing towards standardization, networking, intelligence, and inherent security, achieving an integrated internal and external network security protection system through trusted computing technology.
(4) System architecture is developing towards FCS. From a purely technical perspective, there are currently three ways to integrate fieldbus into a DCS:
① Fieldbus Integration on the DCS System I/O Bus – This involves connecting fieldbus interface cards to the DCS I/O bus, making information from the fieldbus appear to the DCS controller as if it were from a traditional DCS device card.
② Fieldbus Integration at the DCS System Network Layer – This method integrates the fieldbus system to a higher layer of the DCS network. This method requires no modification to the DCS control station and has minimal impact on the existing system.
③ Parallel Integration of Fieldbus and DCS System via Gateway – Fieldbus and DCS can also be integrated in parallel via a gateway bridge. This enables communication between the fieldbus device management system operator station and HART protocol field instruments.

