New & original

One-year warranty

3–5 days

Condition: In stock

 

The IC695PNC001LT is a PACSystems RX3i PROFINET Controller used to manage configured PROFINET devices from an RX3i system. It provides the controller-side network role for remote I/O and other supported PROFINET nodes.

The LT suffix must be treated as part of the catalog identity. Before replacement, save the PROFINET network configuration, device names, IP settings, firmware levels, topology and redundancy details. A mechanically compatible PNC can remain offline if the network identity or project target is not restored.

Model

IC695PNC001LT

Manufacturer

GE

Country of origin

United States

Product family

PACSystems RX3i

Product type

PROFINET Controller module

Network role

Controller for configured PROFINET I/O devices

Rack installation

PACSystems RX3i universal backplane

Project data

Device names, IP settings and topology stored in the controller project

Firmware check

Match CPU, PNC and remote-device support levels

Redundancy check

Verify the installed architecture before replacement

Revision identity

LT suffix; confirm the complete nameplate

Commissioning

Restore configuration and verify all PROFINET device relationships

Model and suffix review

Compatibility check before quotation

 

T/T

Xiamen

3–5 days

In stock

Do not ignore the LT suffix. Confirm the complete order code, environmental requirement, firmware and project hardware catalog before selecting a replacement.

Archive the controller project and record device names, IP addresses, topology, update settings and remote-device catalog numbers. This information is needed to rebuild established controller-device relationships.

The project may not be downloaded, device names may differ, IP settings may conflict, firmware may be unsupported or the physical topology may have changed. Check controller diagnostics and network configuration together.

Provide the RX3i CPU model and firmware, project software version, PNC firmware and every remote PROFINET device revision. Compatibility must be assessed across the complete network.

Document both controller sides, network paths, switches, redundancy settings and synchronized firmware levels. A replacement should be introduced only through the approved system procedure.

Send front and side label photos, firmware, CPU and rack details, topology, device count, quantity and destination. Include the active diagnostic code if the request follows a network failure.

Looking for a difficult automation component?

Send Sales Manager Myrtle the complete IC695PNC001LT label, required quantity and destination. We will review model identity and installed-system compatibility before quotation.