330104-00-13-10-02-05

Name: China Bently Nevada 330104-00-13-10-02-05 3300 XL 8 mm Proximity Probe Manufacturers Suppliers - MOORE
Brand: Moore
SKU: 312330067

Mechanical protection for the lead, non-contact sensing at the tip

This configuration combines an M10 × 1 probe body with an armored lead for installations where the cable needs more protection than an unarmored version provides. The armor helps resist abrasion and incidental contact along the routing path; measurement still depends on a clean probe tip, correct target gap and a compatible 3300 XL extension cable and Proximitor Sensor.

MOUNTING

M10 × 1

Confirm thread engagement, usable reach and locknut position at the actual machine housing.

LEAD PROTECTION

Flexible armor

Route with a generous bend radius and secure against rubbing; armor is protection, not a substitute for support.

SYSTEM CHECK

Match all parts

Probe, extension cable and Proximitor Sensor must form the specified total electrical length.

Plan the route before tightening the probe

01 · Inspect the destination
Check the tapped hole, mounting surface, target path and clearance for the armored cable exit.

02 · Shape a relaxed cable path
Avoid tight turns at the probe body. Keep the route clear of hot edges and moving components.

03 · Secure without crushing
Use supports appropriate for the armor diameter and leave enough compliance for service access.

04 · Verify the measurement loop
Set the probe gap, inspect connections and confirm the monitoring channel response before operation.

330104-00-13-10-02-05 armored proximity probe

Armored probe assembly · use the label to confirm the complete suffix

What armor does-and does not-solve

It helps with: abrasion resistance, guarded routing and incidental mechanical exposure.

It does not solve: incorrect bend radius, unsupported vibration, wrong system length, poor gap setting or mismatch with the Proximitor Sensor.

Replacement rule: an unarmored probe with similar dimensions is not automatically an equivalent substitute.

Typical decision points

Question	Why it matters
Is M10 × 1 the installed thread?	Prevents damage to the housing and preserves the intended probe position.
Is the armor needed along the full exposed route?	Clarifies whether this mechanical configuration matches the service environment.
Do connector and total length match?	Protects the electrical characteristics of the complete 3300 XL channel.
Can the lead be supported correctly?	Reduces fatigue, rubbing and strain near the probe or connector.

Frequently Asked Questions

What is the purpose of the armored lead?

The flexible metal armor adds mechanical protection along the probe lead where routing conditions could expose the cable to abrasion or incidental contact. It does not replace correct supports or clearance from moving parts.

Does armor change the sensing principle?

No. The probe remains a non-contact eddy-current sensing element. The armor protects the lead while the probe tip and matching electronics perform the measurement.

Which ordering details matter most for this model?

Confirm the M10 × 1 mounting arrangement, probe reach and case geometry, total lead length, connector, armor option and approval suffix against the installed system.

Can the cable be coiled tightly inside a junction box?

Avoid tight coils, sharp bends and strain at the probe body or connector. Route the armored lead with a generous bend radius and secure it so vibration cannot cause rubbing.

Is field calibration required after replacement?

A compatible replacement normally follows the established 3300 XL system characteristics, but the complete loop, gap voltage and monitor reading should still be verified before returning the machine to service.

Where is this version typically selected?

It suits installations that need an M10 × 1 probe and added lead protection, including bearing housings, machine cases and routes near service activity or exposed surfaces.

Information that makes a quotation useful

Provide the exact 330104-00-13-10-02-05 number, quantity, installed extension-cable and Proximitor Sensor identifiers, plus photos of the probe label and mounting route. If the request is for a retrofit rather than a like-for-like replacement, include the machine model and available cable-routing space.